Abstract
We propose a method for small displacement measurement based on the angle deviation to phase change transformation. The phase change of common-path heterodyne interferometry due to the angle deviation of incidence of a light at interfaces caused by the displacement is detected by a lock-in amplifier. To obtain more accurate results we used an angular amplifier to increase the angle deviation and utilized a surface plasmon resonance (SPR) sensor to enhance the performance of phase detection. When a translator moves one of two face-to-face plane mirrors at an end and then rotates it a small angle, a light is incident onto the mirrors and reflected N times. The outgoing light is also deflected N times of the angle and incident into a SPR sensor. Thus the phase shift due to the angle deviation is amplified N times. The accumulated phase shift is proportional to the amplified angle deviation and displacement. Therefore, the phase change is obtained and the displacement is measured. The amount of movement required can be as low as 0.13 μm without an SPR sensor or 0.08 μm with an SPR sensor. The maximum measurement range can reach 1000 μm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.