Abstract
The possibility of using three kinds of new type composite materials as material for high speed sliding contacts was investigated. The results of this investigation were compared with the results of the low speed tests that were reported earlier. As a result of the above, it was discovered that for high speed rotation in the range from 0.014 m/s to 2m/s, the order of merit did not significantly change. Based on this, it was concluded that if solid lubricant is effectively supplied to the sliding surface, the influence by frictional heat generated by high speed is slight. Of the three kinds of composite material, it was clarified that composite material (CMML-1) had the lowest contact resistance and Composite Material (CMML-3) had the lowest maximum frictional coefficient of friction. 'CM' and 'ML' are initialisms for 'Composite Material' and 'Material of Lubrication' respectively. The number that is attached to the material name is a numeric value that was set by this laboratory.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
