Skewed-Load Tests for Transition and Stuck-at Faults

Abstract

Listen

Translate article

Test generation procedures target a variety of fault models in order to produce test sets that are effective for defect detection. This paper considers the likely scenario where two-cycle skewed-load tests are generated to detect single transition faults, and the test set is complemented with tests for single stuck-at faults that are not detected by the transition fault test set. For this scenario, this paper makes several unique observations that can be utilized to produce a single compact test set that consists only of two-cycle skewed-load tests for both fault models. The first observation is that a single-cycle test for a stuck-at fault can be transformed into a skewed-load test that is guaranteed to detect the stuck-at fault without performing logic or fault simulation. The second observation is that skewed-load tests, which are transformed from single-cycle tests for stuck-at faults, sometimes detect more transition and stuck-at faults than tests that were generated for transition faults. The third observation is that a static test compaction procedure, which is based on the modification and removal of tests, is effective in this context because it allows tests for stuck-at faults to detect more transition faults and vice versa. This paper describes a test compaction procedure based on these observations and presents experimental results for benchmark circuits to demonstrate the effectiveness of the procedure.