Abstract
A mathematical correlation is developed, based on the thermodynamic model of a downsized gasoline engine, to establish the numerical relationship among the thermodynamic parameters of the combustion chamber. In the developed numerical model, the in-cylinder pressure curves of various operation conditions are simulated by varying the air–fuel ratio in the cylinder, and the associated knock characteristics are recorded. The accuracy of the numerical simulation results is verified against the knock excitation experiment. Then, based on the Rover K16 gasoline engine, a simulation model is developed to simulate the engine knock in the combustion chamber and observe the force acting on the top surface of the piston. The results show that the forces, which act on the piston top surface, are varying at various locations at the same time, and the largest forces occur at the edge of the piston and followed by the piston centre. Then, by comparing the thermo-mechanical coupling strength of the piston under different operating conditions, the results show that the occurrence of the knocking does not exceed the piston’s strength limit. However, the stress and deformation value of the piston is increased significantly, and the failure point of the piston position is changed. Finally, based on the calibrated strength results, the piston durability is predicted for various engine knock conditions. The results show that there is an initial damage of piston in the process of detonation at the surface of the piston pin hole and the joint of the piston cavity. The gasoline engine finally has a predicted mileage of 2,53,440 km continuously, which meet the prescribed mileage of 2,20,000 km.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call