Abstract

The BRTS buses runs on dedicated corridors, trespassing by other vehicles or objects increase chance of accidents. At present there is no automatic system available for monitoring the movements of bus or avoiding possibility of accidents on BRTS corridor. In this paper we have proposed system that uses WSN to monitor vehicular movement and avoid accidents. Wireless sensor network have became most interesting area of research since last decade. The nodes in wireless sensor networks are capable of monitoring the conditions and cooperatively communicate to the network. Each node in the network has critical impact on the system behaviour, so it is important to simulate the functioning of the nodes before its deployment in real world. In this paper we have simulated an accident monitoring and avoiding system using wireless sensor network for Bus Rapid Transit System. This paper is divided into five sections. Introduction of BRTS and wireless sensor network is given in section I, overview of proposed architecture and its solution is discussed in section II, information of the tool used for simulation is given in section III. Simulation work of proposed architecture for accident avoidance is shown in section IV. Finally conclusion is given in section V.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.