Significantly Improving the High-Temperature Tensile Properties of Al17Cr10Fe36Ni36Mo1 Alloys by Microalloying Hf.

Abstract

Dual-phase high-entropy alloys with excellent room temperature and high-temperature properties have been widely studied as potential high-temperature structural materials. However, interface weakening causes its high-temperature performance to decline at higher temperatures, severely limiting further development. In this study, a series of Al17Cr10Fe36Ni36Mo1Hfx (x = 0, 0.03, 0.15, 0.3, 0.5, and 0.8 at%) alloys were prepared to study the effect of Hf content on the microstructure and mechanical properties of the matrix alloy. The results indicate that with the addition of the Hf, the Hf-rich phase began to precipitate at the interface and inside the B2 phase in the matrix alloy. In contrast, the morphology of both the FCC and B2 phases had no noticeable change. With the increase in Hf content, the high-temperature strength and ductility of the alloy first increased and then decreased, while the room temperature performance remained almost unchanged. Benefiting from the hindrance of the Hf-rich phase to grain boundary sliding and dislocation movement during high-temperature deformation, the tensile strength, yield strength, and plasticity of the matrix alloy increased from 474 MPa, 535 MPa, and 8.7% to 816 MPa, 923 MPa, and 42.0% for the Al17Cr10Fe36Ni36Mo1Hf0.5 alloys, respectively. This work provides a new path for designing a high-entropy alloy with excellent high-temperature mechanical properties.