Abstract
The aim of the work was to create a selective gas sensor for hydrogen sulphide. As a result of adding ammonia to the zinc acetate solution, centrifuging the obtained zinc hydroxide and subsequent calcination, a polydisperse zinc oxide powder with a grain size of 5–50 nm was obtained. The material was characterized using X-ray phase analysis and transmission electron microscopy. Subsequently, silver nitrate and terpeniol were added to the zinc oxide nanopowder to form a paste. The gas-sensitive material was obtained by applying the resulting paste on a special dielectric substrate and subsequent calcination, as a result of which the terpeniol burned out, and the silver nitrate turned into an oxide (the mass fraction of the silver was 3%). A non-stationary temperature mode for the operation of the sensor was selected, in which, after rapidheating of the sensor to 450 °C (2 seconds), slow (13 seconds) cooling to 100 °C occurred. Each subsequent heating-cooling cycle with a total period of 15 seconds began immediately after the end of the previous cycle. The use of an unsteady temperature mode in combination with the selection of the composition of the gas-sensitive layer made it possible to obtain a response of 200 for a hydrogen sulphide concentration of 1 ppm. Along with an increase in sensitivity, a significant increase in selectivity was also observed. The cross-sensitivity for the determination of hydrogen sulphide and other reducing gases (CO, NH3, H2) was more than three orders of magnitude. Thus, this sensor can be used to detect hydrogen sulphide even in the presence of interfering components. The use of highly selective sensors in the tasks of qualitative andquantitative analysis can significantly simplify the calibration in comparison with “electronic nose” devices. Devices based on highly selective sensors do not require the use of mathematical methods for processing multidimensional data arrays.
Highlights
IntroductionDue to their high sensitivity, compactness, and low cost, semiconductor gas sensors are often used in the determination of toxic and flammable substances, the area of their possible use is limited by insufficient selectivity [1]
Semiconductor metal oxide sensor for hydrogen sulphide. Due to their high sensitivity, compactness, and low cost, semiconductor gas sensors are often used in the determination of toxic and flammable substances, the area of their possible use is limited by insufficient selectivity [1]
As we demonstrated in our study, the use of non-stationary temperature modes contributes to an increase in the selectivity of the analysis of hydrogen sulphide
Summary
Due to their high sensitivity, compactness, and low cost, semiconductor gas sensors are often used in the determination of toxic and flammable substances, the area of their possible use is limited by insufficient selectivity [1]. The first of them is associated with the use of a matrix of low-selective sensors in multisensor “electronic nose” devices. In this case, mathematical processing of the obtained multidimensional data arrays can lead to the solution of problems of qualitative and quantitative analysis. Mathematical processing of the obtained multidimensional data arrays can lead to the solution of problems of qualitative and quantitative analysis The disadvantages of this approach are the complexity and laboriousness of device calibration, the laboriousness of recalibration when replacing even one sensor, the difficulty of mathematical processing, which requires significant computing resources. The second approach involves the creation of selective sensors, the cross-sensitivity of which to interfering components is rather low
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Kondensirovannye sredy i mezhfaznye granitsy = Condensed Matter and Interphases
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
