Abstract
An in-situ nano-TiB2 decorated AlSi10Mg composite (NTD-Al) powder was fabricated by gas-atomisation for selective laser melting (SLM). Fully dense and crack-free NTD-Al samples were produced using SLM. In contrast to the NTD-Al powder without cell-like microstructure, the SLMed NTD-Al had a textureless microstructure, consisting of fine grains and cells, with well dispersed nano-TiB2 particles inside the grains and rod-like nano-Si precipitates inside the cells. Both nano-TiB2 particles and nano-Si precipitates exhibited a highly coherent interface with the Al matrix, indicative of a strong interfacial bonding. The formation of this microstructure was attributed to the sequential solidification of non-equilibrium and eutectic Al-Si upon rapid cooling during SLM. As a result, the SLMed NTD-Al showed a very high ultimate tensile strength ∼530 MPa, excellent ductility ∼15.5% and high microhardness ∼191 HV0.3, which were higher than most conventionally fabricated wrought and tempered Al alloys, previously SLMed Al-Si alloys and nano-grained 7075 Al. The underlying mechanisms for this strength and ductility enhancement were discussed and a correlation between this novel microstructure and the superior mechanical properties was established. This study provides new and deep insights into the fabrication of metal matrix nanocomposites by SLM from in-situ pre-decorated composite powder.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
