Abstract
There are numerous difficulties involved in drilling operations of an oil well, one of the most important of them being well control. Well control systems are applied when we have irruption of liquids or unwanted intrusion of the reservoir's liquid (oil, gas or brine) into the well, during drilling when the pressure of well fluid column is less than formation pressure, and the permeability of the reservoir has a value that is able to pass the liquid through. For this purpose, a variety of methods including Driller, wait and weight, and the concurrent methods were used to control the well at different drilling sites. In this study, we investigate the optimum method for well control using a fussy method based on many parameters, including technical factors (mud weight, drilling rate, blockage of pipes, sensitivity to drilling network changes, etc.) and security factors (existence of effervescent mud, drilling circuit control, etc.), and cost of selection, which is one of the most important decisions that are made under critical conditions such as irruption. Till now, these methods were selected based on the experience of field personnel in drilling sites. The technical criteria and standards were influenced by experience, so the soft computerizing system (fuzzy method) was used. Thus, both these criteria and standards would be of greater importance and indicate whether the optimum numerical method is the same one that is expressed by human experience. The concurrent method was selected as the best for well control, using the fuzzy method at the end of the evaluation, while field personnel experience suggests the Driller method.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call