Selection of parameters of overhead lines models when calculating transient processes during earth faults in 6–10 kV networks

Abstract

Single phase-to-ground faults are the most common type of faults in 6–10 kV overhead distribution networks. Arc intermittent single phase-to-ground fault (PSP) are the most dangerous for the network and the damaged element. They are followed by intense transient processes and, as a result, dangerous overvoltage rate and significant transient current surges at the point of insulation damage. PSP transients also have a significant effect on the selectivity and operation stability of protection devices against this type of damage. Therefore, the development of the methods and means to improve the operation efficiency of 6–10 kV overhead networks in case of PSP and technical improvement of protection devices in many cases is due to the need to calculate the transient processes that occur during insulation breakdowns of the network phase to earth. For the systems under consideration, the reliability of transient processes calculations in case of PSP is determined mainly by the accuracy of estimation of the parameters of 6–10 kV overhead lines, first of all, of inductance, which generally depends on the frequency of the transient current components. In the scientific papers devoted to the study of transient processes in case of PSP in medium voltage electrical networks, including 6–10 kV overhead networks, constant (frequency independent) values of inductance are used as a rule in the equivalent circuits and in the models of transmission lines. An urgent task is to estimate errors caused by the application of this approach to determine the parameters of 6–10 kV overhead lines during the calculations and modeling of transient processes during PSP, and cases of its application. Advanced methods of modeling of electric power systems and their elements have been applied with the use of COMSOL Multiphysics and PSCAD software to obtain the frequency dependences of the inductances of a 6–10 kV three-phase overhead line and study of their influence on the calculation accuracy of transient currents and voltages in case of PSP. The parameters of 6–10 kV overhead line models developed in the indicated software packages at a frequency of 50 Hz are set in accordance with the reference data. The authors obtain the errors estimation to determine the parameters of transient currents and voltages during PSP in 6–10 kV overhead networks when using transmission line models. The frequency dependences of inductance, which are up to 40–50 % in amplitude are not considered. The results show that application of frequency-independent models is permissible only in the cases when parameters of the calculated equivalent circuit of the network and position of PSP point remain practically constant, when solving problems that require high accuracy to determine the parameters of transient currents and voltages, for example, to determine remotely the location of a ground fault, it is necessary to use frequency-dependent models of 6–10 kV overhead lines. Introduction of the developed recommendations to determine 6–10 kV three-phase overhead lines parameters allow us to increase the reliability of calculations and to avoid raw errors when solving the problems which are related to the study of transient processes in case of earth faults in the networks of the given voltage class.