Seismic behavior of RC columns strengthened with near-surface-mounted aluminum alloy bars and CFRP wraps

Abstract

This paper proposed a near-surface-mounted (NSM) strengthening technique by using aluminum alloy (AA) bars and carbon fiber-reinforced polymer (CFRP) wraps to improve the seismic behavior of square reinforced concrete (RC) columns. Eight strengthened concrete columns with square cross sections of 250 mm × 250 mm and 1600 mm shear span were tested under axial compression and reversal cyclic loading to investigate the effects of NSM reinforcement ratios (0.36–1.29%), layers of CFRP wraps (0 and 3), and axial compression ratios (0.1 and 0.4) on the seismic behavior. The failure mode, hysteretic response, load-bearing capacity, ductility, stiffness degradation, and energy dissipation capacity of those column specimens were analyzed. Results indicated that the lateral load-bearing capacity, stiffness, and cumulative energy dissipation capacity increased with the increase of the NSM reinforcement ratio. The CFRP wraps in the NSM technique can provide hoop confinement to avoid the buckling failure of NSM AA bars, and improve the seismic behavior by mitigating spalling of concrete. When increasing the axial compression ratio from 0.1 to 0.4, the lateral load-bearing capacity and cumulative energy dissipation capacity increased significantly, while the stiffness degradation became obvious. In addition, three-dimensional (3D) finite element (FE) models were developed and verified by comparisons in the deformation and lateral loads at characteristic points, as well as the strain distribution along NSM AA bars. The verified FE models can be used to analyze the damage of concrete and the stress distribution at the interface between epoxy and concrete.