Screening for mineral oil saturated and aromatic hydrocarbons in paper and cardboard directly by planar solid phase extraction and by its coupling to gas chromatography

Abstract

Mineral oil saturated and aromatic hydrocarbons (MOSH/MOAH) are food contaminants, mainly due migration from packaging materials made from recycled fibers, but other routes of entry into food have also been identified. Legal limits for MOSH and MOAH in food and food contact materials currently are not set, but are to be expected in the near future. For the analysis of MOSH and MOAH, the very well developed and highly automated on-line liquid chromatography–gas chromatography with flame ionization detection (LC–GC–FID) is commonly used. However, this approach is time-consuming, and data interpretation is a very challenging task. Therefore, a planar solid phase extraction (pSPE) method was developed for a rapid and efficient MOSH and MOAH screening in paper and cardboard. Based on high-performance thin-layer chromatography (HPTLC), pSPE offers the simultaneous clean-up and analysis of up to 20 samples in parallel, while MOSH and MOAH analytes were focused in two distinct target zones on silica gel HPTLC plates after a twofold development. Plate impregnation with primuline allowed the detection of MOSH by fluorescence, while MOAH were detected by UV light absorption. The pSPE screening approach provided limits of detection of 7.2 and 2.3 ng/zone for MOSH and MOAH, respectively, corresponding to 1.8 and 0.6 mg/kg paper. Coupling of pSPE with GC revealed the common MOSH and MOAH peak humps, while marker substances offered the identification of the mineral oil origin or information about recycled fiber materials. As compared to SPE–GC–FID analyses, the determined quantities of MOSH and MOAH in cardboard samples indicated pSPE as a rapid and suitable screening tool. The co-migration of polyolefin oligomeric saturated hydrocarbons, native n-alkanes, terpenes and possibly essential oils or sterol esters, however, can result in an overestimation of MOSH and MOAH. Hence, samples with pSPE results above a given limit are subsequently analyzed by GC (pSPE–GC) for confirmation and detailed evaluation.