Abstract
The reasons for the low performance of products made by additive growing under extreme operating conditions are investigated. The formation of defects in the crystalline structure at the macrolevel at the interface between the formed layers and the occurrence of high internal stresses are established, which should be considered as the main factor in reducing the mechanical properties of metals formed by 3D printing. To improve the mechanical properties of metals, additional heat treatment is necessary. Keywords: layer-by-layer additive growth of products, internal stresses, heat treatment, improvement of the mechanical properties of metals. uru.40@mail.ru
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.