Abstract

The dehydration of the CPO-27-M (M-MOF-74, M = Zn, Co, Ni, Mg, Mn, Cu) metal-organic framework series has been investigated comprehensively using in situ variable temperature powder X-ray diffraction (VT-PXRD) and thermal analysis (TG) coupled with mass spectrometry (MS). Significant differences in the order of water desorption from different adsorption sites on heating are found with varying metal cation in the otherwise isostructural material. For all CPO-27-M (except M = Cu), water is bonded significantly more strongly to the accessible open metal sites, and these water molecules are only desorbed at higher temperatures than the other water molecules. CPO-27-Cu is an exception, where all water molecules desorb simultaneously and at much lower temperatures (below 340 K). MS and TG data show that all CPO-27-M start to release traces of CO2 already at 300–350 K, and thus long before bulk thermal decomposition is observed. Only for CPO-27-Co, the CO2 release is essentially constant on its baseline between 450 and 700 K, and it is the only CPO-27-M member that shows a stable plateau in the TG in this region. Additional rehydration studies on CPO-27-Co show that the MOF incorporates any water molecules present until the pores are fully loaded. CPO-27-Co consequently behaves as an efficient trap for any water present.

Highlights

  • Metal-Organic Frameworks (MOFs) are coordination networks composed of metal moieties and organic ligands that contain voids [1]

  • The dehydration of the CPO-27-M (M-MOF-74, M = Zn, Co, Ni, Mg, Mn, Cu) metal-organic framework series has been investigated comprehensively using in situ variable temperature powder X-ray diffraction (VT-PXRD) and thermal analysis (TG) coupled with mass spectrometry (MS)

  • It is of paramount importance for their applications to understand how MOFs behave upon dehydration and, in particular, whether they remain stable upon solvent removal [14,15,16,17]

Read more

Summary

Introduction

Metal-Organic Frameworks (MOFs) are coordination networks composed of metal moieties and organic ligands that (at least poten­ tially) contain voids [1] Due to their porous nature and exceptionally high surface areas this class of materials is attractive for applications in catalysis, gas storage, separation processes and as po­ tential sensor material [2,3,4,5,6,7,8,9,10,11,12,13]. The dehydration processes of CPO-27-Co and Zn were

Current address
Experimental section
Instrumentation
Synthesis
Results and discussion
Dehydration of CPO-27-Mg
Dehydration of CPO-27-Ni
Dehydration of CPO-27-Mn
Dehydration of CPO-27-Cu
Dehydration of CPO-27-Co
Dehydration of CPO-27-Zn
Comparison of results for the different CPO-27-M materials
Hydration of CPO-27-Co
Conclusions
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.