Role of Molecular and Interchain Ordering in the Formation of a δ-Hole-Transporting Layer in Organic Solar Cells.

Abstract

Interface engineering, especially the realization of Ohmic contacts at the interface between organic semiconductors and metal contacts, is one of the essential preconditions to achieve high-efficiency organic electronic devices. Here, the interface structures of polymer/fullerene blends are correlated with the charge extraction/injection properties of working organic solar cells. The model system-poly(3-hexylthiophene) (P3HT):phenyl-C61-butyric acid methyl ester (PCBM)-is fabricated using two different degrees of P3HT regioregularity to alter the blend interchain order and molecular packing, resulting in different device performances. Investigations by electroabsorption spectroscopy on these devices indicate a significant reduction (≈1 V) in the built-in potential with an increase in the P3HT regioregularity. This observation is also supported by a change in the work function (WF) of high regioregular polymer blends from photoelectron spectroscopy measurements. These results confirm the presence of a strong dipole layer acting as a δ-hole-transporting layer at the polymer/MoO3/Ag electrode interface. Unipolar hole-only devices show an increase in the magnitude of the hole current in high regioregular P3HT devices, suggesting an increase in the hole injection/extraction efficiency inside the device with a δ-hole-transporting layer. Microscopically, near-edge X-ray absorption fine structure spectroscopy was conducted to probe the surface microstructure in these blends, finding a highly edge-on orientation of P3HT chains in blends made with high regioregular P3HT. This edge-on orientation of P3HT chains at the interface results in a layer of oriented alkyl side chains capping the surface, which favors the formation of a dipole layer at the polymer/MoO3 interface. The increase in the charge extraction efficiency due to the formation of a δ-hole-transporting layer thus results in higher short circuit currents and fill factor values, eventually increasing the device efficiency in high regioregular P3HT devices despite a slight decrease in cell open circuit voltage. These findings emphasize the significance of WF control as a tool for improved device performance and pave the way toward interfacial optimization based on the modulation of fundamental polymer properties, such as polymer regioregularity.