Abstract
Technologies for pattern fabrication using imprint process are being developed for various devices. Nanoimpirnt lithography (NIL) is an attractive and promising candidate for its pattern fidelity toward finer device fabrication without using double patterning. To apply smaller pattern size device, layout dependent hotspots becomes a significant issue, so design for manufacturing (DFM) flow considering imprint process has to be prepared. In this paper, focused on fine resist spread, RLT (Residual Layer Thickness) uniformity improvement utilizing simulation is demonstrated and resist drop compliance check flow is proposed
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
