Rising R-curves in particulate/fiber-reinforced resin composite layered systems

Abstract

Listen

Translate article

BackgroundAn anisotropic fracture behavior has already been successfully induced in a condensable resin composite by reinforcement with discontinuous glass fibers, developing a steep rise in the fracture resistance curve. There is still the need for developing such concepts further, by evaluating the behavior of layered structures that attempt to replicate the natural gradient structure of enamel and dentin. MethodsMonolithic and bilayer specimens of a flowable short-fiber particulate-reinforced composite (SFPRC) material (GC Corp.) and a commercial flowable particulate-reinforced composite (PRC) (Essentia HiFlo, GC Corp.) were produced with the fibers aligned perpendicular or randomly oriented to the plane of crack propagation. Pre-cracked specimens were tested in 3-point bending using the single-edge-V-notch-beam method with accurate displacement tracking recordrecord. Controlled crack growth experiments were conducted at progressive crack extension intervals to build R-curves using linear-elastic and elastic-plastic fracture mechanics. ResultsWe demonstrate firsthand the development of R-curves in resin composite bilayers, with crack arrest at the interface and a steep rise in crack resistance with subsequent drop within the SFPRC layer. Crack deflection and fiber bridging were found to contribute to a higher rise in the R-curves for specimens with aligned fibers; still, randomly oriented fibers showed significant R-curve development, especially at short range intervals. An increase in the vol% of fibers and a decrease in the Young's modulus contributed to a higher overall performance of the flowable vs. the condensable SFPRF materials. ConclusionsSFPRC materials show an up to 5-fold improvement in the fracture resistance over conventional PRCs, and show the potential to be used to build gradient structures by varying the fiber alignment and fibers parameters (length and packing).