Riboflavin Osmolar Modification for Transepithelial Corneal Cross-Linking

Abstract

Purpose: To investigate the influence of osmolarity on the transepithelial permeability of riboflavin solutions in a cross-linking procedure.Methods: Several riboflavin 0.1% solutions that contained different NaCl and benzalkonium chloride (BAC) concentrations were applied to 36 rabbit eyes for 30 min. To serve as a control, the epithelium was removed in group A (standard protocol). The groups then received the following solutions: (A) riboflavin 0.1% in NaCl 0.9% solution; (B) riboflavin 0.1% in NaCl 0.44% solution with BAC 0.02%; (C) riboflavin 0.1% in NaCl 0.44% solution with BAC 0.01%; (D) riboflavin 0.1% in NaCl 0.44% solution without BAC; (E) riboflavin 0.1% in NaCl 0.9% solution with BAC 0.02%; and (F) riboflavin 0.1% in NaCl 0.9% solution without BAC. Six eyes in each group were treated. The absorption coefficients of the corneas were measured to characterize the riboflavin penetration into the cornea.Results: There is a large difference in the transepithelial riboflavin penetration of riboflavin 0.1% + BAC 0.02% solutions that contain different NaCl concentrations (NaCl 0.9% versus NaCl 0.44%). The absorption coefficients differed by more than a factor of two (P = 0.004). No statistically significant difference was found between riboflavin 0.1% in NaCl 0.44% solution containing BAC 0.02% and BAC 0.01%. Compared to the standard protocol, these solutions resulted in an absorption coefficient of 37% (BAC 0.02%) and 33% (BAC 0.01%) of the standard epithelium-off procedure.Conclusion: The transepithelial riboflavin solution should contain no dextran, but it should include 0.01% BAC and 0.44% NaCl to promote the permeability of riboflavin through the epithelium, resulting in a sufficient concentration of riboflavin in the corneal stroma.