Abstract
The present work describes an experimental investigation of Cu-doped ZnO–EG hybrid nanofluids for better viscous nature and thermal efficiency in cooling systems. The initial phase involves synthesizing copper (Cu) doped zinc oxide (ZnO) nanoparticles using chemical precipitation method. The structural and morphological properties of these nanoparticles are determined using X-ray diffraction (XRD), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). Thermo-physical measurements are conducted to analyze the viscosity and thermal conductivity of Cu-doped ZnO nanofluids based on ethylene glycol (EG) at varying particle concentrations (ranging from 0.01 wt% to 0.08 wt%) with various temperature ranges of 298 K to 328 K. The observed rheological properties showed that the viscosity of tested Cu-doped ZnO-EG nanofluids exhibited non-Newtonian shear-thinning behavior due to the alignment of nanoparticle agglomerates with increasing shear rate. Similarly, the thermal properties of the prepared Cu:ZnO-EG nanofluids are examined, demonstrating a smooth increase in thermal conductivity with changes in particle concentration and temperature. The thermal conductivity ratio of the nanofluids suggests that the newly developed hybrid nanofluids exhibit superior heat transfer characteristics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.