Abstract

AbstractThe rheology of two polyamide 6.6 systems filled with long glass fibers, as well as at of a three‐phase polyamide 6.6‐glass fiber‐gas bubble system, was studied using capillary rheometry, To investigate the influence of fiber concentration, the shear and extensional viscosities were determined for both 30 and 40 vol% fiber filled suspensions as well as for the base polymer. Comparison revealed a modest increase in both the shear and extensional viscosities with increased fiber fraction. The shear viscosities, ηs, of both suspensions are shown to be close to one order of magnitude greater than the base matrix fluid viscosity, η. However, the extensional viscosities, ηE, of the suspensions are determined to be approximately four orders of magnitude greater than the shear viscosity of the matrix fluid for strain rates from 100 s−1 to 102 s−1. The addition of a gas bubble phase to the neat polymer and polymer‐fiber suspensions was accomplished through the decomposition of various percentages of an azodicarbonamide blowing agent. The presence gas bubbles resulted in reduced shear and extensional viscosities for both the neat and fiber‐filled polyamide with greater reductions observed for the neat polyamide. Greater viscosity reductions were observed as the blowing agent centration was increased.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.