Abstract
Most of Partial Discharge (PD) processing systems have been developed using virtual instrument to analyse raw measured PD signal. However, some of researchers had neglected the denoising or recognition technique and only focussed on PD location estimation and vice versa This paper reviews an overview of denoising recognition techniques, denoising analysis, PD sensors, location methods and type of virtual instruments in published PD signal processing signal system. A perfect PD analysis system is more beneficial if both PD denoising and locating are applied in the system. Based on this review, the new design of PD signal processing system based on DWT denoising technique and RC sensor using LabVIEW Software for underground power cable using SCTM as PD location algorithm is proposed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
