Abstract
This study investigated the impact of varying total ammonia nitrogen (TAN) feed levels along with water temperature decreases on the performance of nitrifying moving bed biofilm reactor (MBBR) at 1 °C and its recovery at 3 °C. Five MBBR reactors were operated with different TAN concentrations as water temperature decreased from 20 to 3 °C: reactor R1 at 30 mg N/L, reactor R2 at 20 mg N/L, reactor R3 at 15 mg N/L, reactor R4 at 10 mg N/L and reactor R5 at 0 mg N/L. The corresponding biofilm characteristics were also analyzed to understand further nitrifying MBBR under different TAN feeding scenarios. The findings revealed that the higher TAN levels were before reaching 1 °C, the better nitrification performance and the more biomass grew. However, the highest TAN concentration (30 mg N/L) might negatively affect the nitrification performance, the activity of nitrifiers, and the growth of biofilms at 1 °C because of the toxic effects of un-ionized or free ammonia (FA). It was observed that the activities of ammonia-oxidizing bacteria (AOB) and nitrite-oxidizing bacteria (NOB) were affected by FA concentrations ranging from 0.2 to 0.7 mg N/L at 1 °C, but they could gradually be adapted to such inhibitory environment, with NOB recovering more quickly and robustly than AOB. The study identified 20 mg N/L (67 % of maximum influent TAN at 1 °C in R2 as the optimal TAN feeding concentration, achieving over 90 % TAN removal and a surface area removal rate (SARR) of 0.78 ± 0.02 g N/m2·d at 1 °C. Meanwhile, R2 also exhibited the highest biofilm mass, with total solids at 13.3 mg/carrier and volatile solids at 11.3 mg/carrier. As TAN was removed, nitrite accumulation was observed at 1 °C, and higher influent TAN concentrations prior to 1 °C appeared to delay the accumulation. When water temperature increased from 1 °C to 3 °C, nitrification performance improved significantly in all reactors without nitrite accumulation, and the higher TAN feeding in the previous stage led to faster recovery. Compared with 20 °C, biofilm became thinner and denser at 1 °C and 3 °C. Furthermore, this study revealed significant shifts in microbial community composition and nitrifier abundances in response to changes in water temperature and influent TAN levels. The dominant nitrifiers were identified as Nitrosomonadaceae (AOB) and Nitrospiraceae (NOB). At 1 °C, the nitrifier abundances were significantly correlated with SARRs, FA, and biofilm density. R2, which exhibited the best nitrification performance, maintained higher nitrifier abundances at 1 °C.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.