Research on underwater acoustic detection technology based on optical waveguide resonator cavity

Abstract

Purpose In acoustic detection technology, optical microcavities offer higher detection bandwidth and sensitivity than traditional acoustic sensors. However, research on acoustic detection technologies involving optical microcavities has not yet been reported. Therefore, this paper aims to design and construct an underwater acoustic detection system based on optical microcavities and study its acoustic detection technology to improve its performance. Design/methodology/approach Based on the principles of optical microcavity acoustic sensors, a signal-detection circuit was designed to form a detection system in conjunction with a laser, an optical waveguide resonator and an oscilloscope. This circuit consists of two modules: a photodetection module and a filter amplification module. Findings The photodetection module features a baseline noise of −106.499 dBm and can detect device spectral line depths of up to 2410 mV. The gain stability of the filter amplification module was 58 dB ± 1 dB with a noise gain of −107.626 dBm. This design allows the acoustic detection system to detect signals with high sensitivity within the 10 Hz−1.2 MHz frequency band, achieving a maximum sensitivity of −126 dB re 1 V/µPa at 800 Hz and a minimum detectable pressure (MDP) of 0.37 mPa/Hz1/2, corresponding to a noise equivalent pressure (NEP) of 51.36 dB re 1 V/µPa. Originality/value This study designs and constructs a broadband underwater acoustic detection system specifically for optical waveguide resonators based on the sensing principles of silicon dioxide optical waveguide resonators. Experiments demonstrated that the signal detection module improves the sensitivity of underwater acoustic detection based on optical waveguides.