Abstract
The objective of the experimental research presented in this paper was to analyze the relationship between the cutting power and the roughness parameters characterizing the Spruce wood and MDF panel, brush sanded with two grit sizes, namely P180 and P220. Sets of samples were analyzed for each sanding conditions. The variables of the processing parameters were considered to be the feed speed and the rotation speed. The power consumption was measured using a power monitor device. The roughness was measured on a stylus based detector. The assessment of the quality of the sanded surfaces and the optimum energy was carried out by comparing these parameters, depending on the applied processing parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
