Research on microstructure and mechanical behaviour of smaller microbumps for high density solder interconnects

Abstract

PurposeThe purpose of this paper is to study the microstructure and mechanical behaviour of smaller microbumps for high density solder interconnects.Design/methodology/approachThe microstructure was analyzed by scanning electron microscopy and electron backscatter diffraction tests to determine the Sn grain number of the resultant microbumps. The nanomechanical properties of Sn microbumps were investigated by the nanoindentation and shearing tests to understand the failure mechanism and assess the reliability of ultra-high density solder interconnects with numbered grains.FindingsOnly one Sn grain is observed in the interconnect matrix when the microbumps are miniaturized to 40 μm or less. Because of the body-centred tetragonal lattice of ß-Sn unit cell, the mechanical properties of the one-grain Sn microbumps are remarkably anisotropic, which are proved by the difference of the elastic modulus and the stiffness in the different orientations. The shearing tests show that the one-grain Sn microbump has a typical brittle sliding fracture of monocrystal at different shearing speeds.Practical implicationsThe paper provides a comparable study for the performance of the bigger solder joints and also makes preliminary research on the microstructure and mechanical behaviour of Sn microbumps with the diameter of 40 μm.Originality/valueThe findings in this paper provide methods of microstructure study by combination of EBSD test and metallographic analysis, mechanical study by combination of nanoindentation test and shearing test, which can provide good guidelines for other smaller microbumps. The strain rate sensitivity exponent of the one-grain Sn microbumps is consistent with the Pb-free bulk solder. This implies that the one-grain Sn microbump has a comparable flow stress to Sn37Pb solder, which is beneficial for Pb-free replacement in higher density microelectronic packaging.