Abstract
The article deals with the investigation of tribological properties of polycarbonate (PC) material produced by 3D printing using Fused Deposition Modelling (FDM) technology under different layer deposition strategies and their subsequent testing for abrasive wear. The aim of the experiment was to compare the effect of different layer deposition strategies in the FDM process on the abrasive wear of the material at specified process parameters, which were defined according to ASTM G65 standardized tests. Based on these tests, the different strategies were compared and evaluated in terms of their ability to resist abrasive wear, providing insight into the effect of different orientations and layer arrangements on the tribological properties of 3D printed polycarbonate.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.