Research and design of broadband muffler based on second-order Helmholtz resonators

Abstract

Noise is always a serious factor affecting people's quality of life. The most common sound-absorbing materials are porous materials, which work based on the principle that sound waves entering into the pores inside the material are subjected to air friction and viscous resistance, thus converting sound energy into heat. Porous materials have excellent performance of absorbing medium-frequency and high-frequency sound , but they are required to be thick enough to control the low-frequency sound waves with large wavelengths, which limits the application of porous materials in low-frequency noise control. In recent years, acoustic artificial structures have become a research hotspot, which can realize exotic effective acoustic parameters based on periodical structure or local resonance. Acoustic artificial structure provides a new material basis for noise control, in which Helmholtz resonator plays an important role because of its simple geometry. In this study, a broadband muffler is designed based on the second-order neck embedded Helmholtz resonator. In order to achieve low-frequency and broadband sound insulation with a limited number of units and structure length, the second-order resonator is chosen as a basic structure unit, which has a stronger low-frequency noise reduction capability and has one high-frequency transmission loss peak more than a conventional Helmholtz resonator. The acoustic characteristics and insulation performance of second-order resonators are analyzed through theoretical calculation, simulation calculation and experimental test. Then, based on the theoretical model and empirical rules, a broadband muffler composed of nine second-order resonators is designed by carefully adjusting the geometry parameters of each resonator. The three-dimensional printed resonators are installed on the side wall of a square standing wave tube for experimental measurement. In the experiment, the transmission loss curve of the muffler is measured by the two-load method. The result shows that the designed muffler has good sound insulation performances in a frequency range of 267–927 Hz, with the whole transmission loss above 20 dB and the maximum sound insulation up to 60 dB. The experimental result is consistent with the calculation result and simulation result. The muffler has simple structure and high practicability, which will have a wide application prospect in noise control engineering.