Abstract
This paper describes a study concerning the inner turning of a piece of duralumin, using 6 values of the feed. The shapes and micro-geometry of the resulting chips have been observed experimentally and these are explained by the large deformations in the cutting area. The processed surfaces, both by enlarging them to a microscope and by measuring the roughness have been experimentally studied. Also, the sections of chips are analysed, giving the theoretical and real dimension values, also interpreted on the basis of the deformations in the cutting area. Also, values of roughness parameters are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
