Abstract

The paper compares the quality of machined surface of graphite and aluminium alloy by abrasive waterjet using the focusing tube with a diameter of d f1 = 0.5 mm and d f2 = 0.78 mm. The machining was carried out using the technology of rotating workpiece disintegration by abrasive waterjet. Abrasive tangential waterjet was used to carry out the experiment (water pressure P = 400 MPa). Workpieces were clamped in the rotating chucking appliance with rotation frequency n = 300 min−1. The change in focusing tube diameter caused the change in values of roughness parameters and also caused the change of resulting shape of workpieces. Values of roughness parameters were measured using the MicroProf FRT optic profilometer.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.