Abstract
Injection compression molding (ICM) with high aspect ratio surface features was performed to clarify the effect of molding conditions on replication characteristics and molecular orientation distribution. Short-shot defects and surface replication were better when using ICM than when using conventional injection molding. A long compression stroke and short delay time condition were optimum conditions to used to achieve uniform surface replication. Molecular orientation was also reduced by the long compression stroke. To reduce molecular orientation, the compression motion should be carried out immediately after injection motion in the case of 0.2 mm thickness. For 0.6 mm thickness, the compression motion was conducted after the shear stress relaxation to reduce the molecular orientation. Short-shot tests revealed distinctive replication behavior in ICM. Results show that replication behavior and local molecular orientation are generated by a slightly frozen layer at the filling area before compression.
Paper version not known (
Free)
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call