Repetitively pulsed streamer discharge with laser-induced surface trapped electron desorption to exploit residual charges in situ

Abstract

Abstract Positive streamer behaviors under repetitive pulses are predominantly dependent on the availability of free electrons. If surface residual electrons stored from previous discharges could be intentionally released and involved into the next discharge, an alternative control freedom is provided apart from voltage waveform tailoring methods that mainly attract or repel gaseous residual charges. Evolutions of repetitively pulsed surface streamers in compressed (0.2 MPa) air were investigated after low-photon-energy pulsed visible (532 nm) and infrared (1064 nm) laser irradiations. Pulse-sequence and temporally resolved diagnostics were implemented to investigate effects of laser parameters (irradiation moment, wavelength, energy) and gas composition. A 2D surface streamer fluid simulation was performed to qualitatively unveil impacts of localized plasma patches. The surface streamer morphology and emission light are significantly and repeatably affected by the laser irradiation before the streamer inception, while, variations totally disappear without the solid surface. The secondary streamer is prolonged accompanied by a higher flashover probability after the pulsed laser irradiation in compressed air. Intriguingly, influences of the infrared laser persist for tens of microseconds before the next voltage pulse. Residual charge dynamics under the laser irradiation are analyzed, where the additional increase of O- 2 of low electron bound energy is emphasized. The laser induced surface trapped electron desorption is achieved through the direct or the step-wise process, dependent on the laser energy and the surface trap state distribution.