Removal of Mn 2+ ions from drinking water by using Clinoptilolite and a Clinoptilolite–Fe oxide system

Abstract

Clinoptilolite, a natural zeolite, was used for the synthesis of a high surface area Clinoptilolite–Iron oxide system, in order to be used for the removal of Mn 2+ ions from drinking water samples. The new system was obtained by adding natural clinoptilolite in an iron nitrate solution under strongly basic conditions. The Clin–Fe system has specific surface area equal to 151.0 m 2/g and is fully iron exchanged (Fe/Al=1.23). Batch adsorption experiments were carried out to determine the effectiveness of the Clin and the Clin–Fe system in removal of manganese from drinking water. Adsorption experiments were conducted by mixing 1.00 g of each of the substrates with certain volume of water samples contaminated with 10 different Mn concentrations (from 3.64×10 −6 to 1.82×10 −2 M or from 0.2 to 1000 ppm). For the present experimental conditions, the Mn adsorption capacity of Clin was 7.69 mg/g, whereas, of Clin–Fe system was 27.12 mg/g. The main factors that contribute to difference adsorption capacity of the two solids are due to new surface species and negative charge of Clin–Fe system. In addition, the release of counterbalanced ions (i.e., Ca 2+, Mg 2+, Na + and K +) was examined as well as the dissolution of framework Si and Al. It was found that for the most of the samples the Clin–Fe system releases lower concentrations of Ca, Mg and Na and higher concentrations of K than Clin, while the dissolution of Si/Al was limited. Changes in the composition of water samples as well as in their pH and conductivities values were reported and explained.