Removal of chromium from tanning wastewater and its reuse

Abstract

The chromium (Cr) used in the manufacture of leather from hides has well-known adverse effects when inappropriately disposed in the environment. The tanneries use large quantities of water for processing hides. The recovery of Cr from the wastewater produced in the tanning step is an environmentally friendly and economically viable alternative avoiding the disposal of large amount of Cr-containing sludge in industrial hazardous waste landfills. This work aims at studying the removal of the Cr from the tanning wastewater through chemical precipitation (CP) and electrocoagulation (EC) techniques and its reuse in tanning process. In the CP experiments, efficient Cr removal from wastewater samples was achieved, with up to 99.74% removal efficiencies. In the EC experiments, three different electrode materials, Al, Cu, and Fe were tested. The highest removal efficiency of 97.76% was obtained with Al electrodes by conducting electrolysis at 3.0V for 110min. This was followed by Fe electrodes and Cu electrodes, which showed removal efficiencies of 90.27% (at 2.5V) and 69.91% (at 2.0V), respectively, for an electrolysis of 100min. The recovered Cr was reused as a tanning agent in leather processing, where good crossing of Cr was reached in leathers tanned with the liquors prepared from the sludge, and the pH and ash content values were measured. While the hides tanned with the Cr-containing liquor recovered by CP and by EC with Cu electrodes showed good hydrothermal stability and Cr content above 2.5% Cr2O3, the hides tanned with Cr-containing liquors recovered by chemical precipitation and by EC conducted with Fe and Cu electrodes showed contents of Cr according to technical specifications. However, the Cr samples obtained with the iron electrode showed a dark coloration due to oxidation of the iron. It can be concluded that the tanning process with Cr recovered by CP and by EC with Cu electrodes showed the best results.