Removal of Ammonia from Aqueous Solutions, Ground Water, and Wastewater Using Mechanically Activated Clinoptilolite and Synthetic Zeolite-A: Kinetic and Equilibrium Studies

Abstract

Natural zeolite clinoptilolite and synthetic zeolite Na-A were characterized using XRD and SEM to be used as adsorbents for ammonia from aqueous solutions, ground water, and sewage water. Clinoptilolite was mechanically activated for 2, 4, 6, and 8 h to study the effect of activation in enhancing the adsorption capacity. The adsorption by activated natural zeolite and synthetic zeolite is high pH dependent and achieve the best values at pH = 7. The adsorption capacity of activated natural zeolite increases with increasing the activation from 2 to 8 h achieving removal percentage close to that obtained using synthetic zeolite. The equilibrium was obtained after 60 min for synthetic zeolite and all the activated natural zeolite (except 2-h-activated product, the equilibrium was achieved after 30 min). The kinetic studies reflected the high fitness of the adsorption results of activated natural zeolite products and synthetic zeolite with pseudo-second-order model rather than the other kinetic models. The obtained isotherms reflected the formation of S-type isotherm curve for the adsorption using mechanically activated clinoptilolite and L-type curve for the uptake using synthetic zeolite. The results represented well with Langmuir model followed by Temkin and Freundlich model for adsorption using synthetic zeolite. The uptake using mechanically activated clinoptilolite can be represented by Temkin model rather than both Langmuir and Freundlich models. Thermodynamic parameters indicate spontaneous endothermic adsorption of ammonia using all the zeolitic products under investigation. Finally, the mechanically activated natural zeolite and synthetic zeolite exhibit high efficiency in the removal of ammonia and other water pollutants from ground water and sewage water.