Remarkable photodegradation breakdown cost, antimicrobial activity, photocatalytic efficiency, and recycling of SnO2 quantum dots throughout industrial hazardous pollutants treatment

Abstract

In the conducted research, a one-step hydrothermal synthesis of pure and titanium-doped tin dioxide quantum dots is elaborated upon, with a thorough analysis of their structural, optical, morphological, and photocatalytic properties undertaken using advanced analytical techniques. Through X-ray Diffraction XRD, the crystalline nature and phase purity of the tetragonal structures of SnDs were confirmed, with the crystallite sizes measured at 3.0 nm for SnD1 and 7.66 nm for SnD2, following treatments at 240 °C and 300 °C, respectively. The structural integrity of SnO2 was maintained despite titanium doping. FTIR spectroscopy verified the existence of specific vibrational modes indicative of surface hydroxyl groups. HRTEM images revealed the spherical morphology of particles, with diameters of 3.5 nm for SnD1 and 9.1 nm for SnD2. Optical band gaps, determined through UV-DRS, ranged from 3.33 eV in SnD1 to 3.47 eV in SnDTi2. The photocatalytic degradation of Congo Red dye under xenon lamp irradiation was quantitatively assessed; notably, SnD1 exhibited a 23 % higher rate constant compared to SnD2, attributed to its smaller particle size and a 31 % greater surface area. Doping with 4 % Ti in Sn0.96Ti0.04O2 more than doubled the degradation rate compared to a 6 % Ti doping in Sn0.94Ti0.06O2. Furthermore, the generation of hydroxyl radicals was significantly enhanced, showing an increase of approximately 220 % for SnD1 and 80 % for SnD2. The capability of these nanomaterials to reduce the chemical oxygen demand of industrial organic pollutants to within regulatory limits under solar irradiation was documented, with SnD1 maintaining its photocatalytic efficiency over seven cycles of reuse. In the photocatalytic degradation rate of Congo Red dye, which was 23 % higher for SnD1 compared to SnD2, and the threefold increase in the degradation rate for SnDTi1 compared to SnDTi2. An economic assessment, based on electricity tariffs in Saudi Arabia, highlighted the cost-effectiveness of SnD1, which ranged from 26.93 to 30.36 USD per breakdown cost of the photodegradation process, showing it to be less costly than SnD2. Conversely, SnDTi1 was found to be more economical than SnDTi2, with costs ranging from 26.67 to 33.09 USD. Collectively, the results emphasize the outstanding photocatalytic performance and cost-efficiency of SnDs, reinforcing their potential as sustainable solutions for the treatment of industrial wastewater. Additionally, the antibacterial efficacy of these materials against a range of bacteria, yeast, and fungi was investigated and substantiated.