Abstract
In a general wireless sensor network, a sink node collects data from each node successively and then post-processes the data to obtain useful information. However, conventional methods have a scalability problem: the data collection/processing time increases with the number of nodes, and frequent transmission collisions degrade spectrum efficiency. If only statistical values of the data are needed, using over-the-air computation (AirComp) can efficiently perform data collection and computation. However, AirComp also has its problems: when the channel gain of a node is too low, (i) the transmission power of that node will be high, decreasing the lifetime of that node and the entire network, and (ii) sometimes, the computation error still occurs even though the maximal transmission power is used. To jointly solve these two problems, in this paper we investigate the relay communication for AirComp and study a relay selection protocol. The basic method selects an ordinary node with a good channel condition as a relay node, considering both computation error and power consumption. This method is further enhanced to explicitly consider network lifetime in relay selection. Extensive simulation evaluations confirm that the proposed method helps to prolong the lifetime of the entire network and reduce computation errors as well.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
