Abstract
Selecting proper guided wave exciting frequency is of important practical significance in the engineering application of guided wave non-destructive testing(NDT).The characteristic of guided wave propagation in pipes that L(0, 1) and L(0, 2) have a cutoff frequency are respectively discussed, and the calculation formulas of their cutoff frequency are given.The varied relationship between the cutoff frequency of L(0, 1) and L(0, 2) mode guide waves, the outer diameter and wall thickness of pipes are discussed respectively.For a given steel pipe, experiments are carried out by selection of different exciting frequency.The results show that the"low-pass"type cutoff frequency of L(0, 1) and"high-pass"type cutoff frequency of L(0, 2) are reduced with the increase of outer diameter of pipes, and the"low-pass"type cutoff frequency of L(0, 1) and"high-pass"type cutoff frequency of L(0, 2) initially increase with the increase of wall thickness of pipes, but the increased amplitude decreases slowly.When the outer diameter of pipes attains a certain value, both of the cutoff frequencies are irrelevant to wall thickness of pipes.The experimental results are in agreement with theoretical computation of selected exciting frequency for guided wave NDT of pipes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.