Abstract
This study evaluated the effect of high-pressure nitrogen (N2) gas injection prior to spray drying on the subsequent rehydration properties of regular and agglomerated milk protein concentrate (MPC) powders. Conductivity measurements demonstrated a slower release of ions for powders produced using N2 injection (NI) as they took longer to wet and sink due to their lower density. However, analysis of particle size distribution on reconstitution at both 23 and 50 °C showed an improvement in powder dispersion with NI. Powder solubility, when measured at 23 °C, was higher for the NI powders, while agglomeration negatively impacted solubility. Confocal laser scanning microscopy analysis showed a faster diffusion of dye into MPC powder particles produced using NI. The improvement in powder dissolution with NI was attributed to higher porosity and the presence of air voids which facilitated increased water transfer and accelerated the breakdown of primary powder particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
