Abstract
The automotive component company is engaged in the manufacture of automotive rubber components. Based on data obtained from field observations, it was found that the Dandori process on the swaging Nox machine, especially TA090 type, had the highest downtime compared to another component. Based on these problems, research uses the Single Minute Exchange of Die (SMED) method to reduce Dandori downtime in the TA090 swaging process. The SMED method was carried out in three stages: 1. identify internal and external setup, 2. Converting internal to external setup, and 3. Streamlining aspects of operation. In addition, it also used data processing tools, namely SMART, fishbone, and 5W+1H as support to solve this problem. Improvements were made by converting internal work elements into external ones and streamlining aspects of operation by improving on man, method, and machine/tools categories. The result of these improvements was a decrease in downtime of 39 minutes 48 seconds and the improvement efficiency achieved was 81.2%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Operations Excellence: Journal of Applied Industrial Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
