Real-time navigation solutions of low-cost off-the-shelf GNSS receivers on board the Astrocast constellation satellites

Abstract

With the ever-increasing number of small satellites launched into space, on-board orbit determination is becoming more and more important. Precise satellite positions are needed for constellation maintenance, formation flying, communication optimization, collision avoidance and Earth observation. In addition, accurate time information is required for the functioning of the instruments on board. Low-cost off-the-shelf Global Navigation Satellite System (GNSS) receivers and antennas, adapted to the small size and weight of the satellite, allow precise on-board orbit determination and time synchronization for even the smallest satellites.We analysed more than one year of on-board navigation solutions (NAVSOL) from 8 Astrocast CubeSats, which are equipped with our multi-GNSS single-frequency payload. Based on the residuals from a dynamic orbit fitting, we found that the quality of the NAVSOL from the Astrocast satellites varies strongly both over time and between satellites, with an RMS ranging from a few meters to several tens of meters.In this study, we focus on three main effects that influence the quality of the NAVSOL from the Astrocast satellites: (1) The orbit-fit residuals show a positive radial offset in the range of about 6 m to 15 m, which is caused by ionospheric refraction. Our data show that GNSS signals at negative elevations are very strongly affected by the ionospheric refraction and thus account for the major part of the radial offset. (2) Discrepancies between the NAVSOL positions and velocities, and simulations with a GNSS signal generator show a once-per-revolution periodicity in the out-of-plane component, with amplitudes of 2 m and 5 cm/s in position and velocity, respectively. This effect is probably due to an inappropriate dynamic model used in the real-time navigation algorithm of the GNSS receiver. (3) Depending on the location of the GNSS antenna on board the satellite, the noise level varies by a multiple. This is assumed to be due to the antenna orientations, interference of the GNSS signals with electromagnetic waves coming from the satellite platform, signal attenuation during the transmission from the antenna to the receiver and differences in the soldering or tuning of the individual GNSS antennas.These findings help us refine hardware configurations and firmware settings in preparation for future Astrocast satellites or other nanosatellite missions. By eliminating or minimizing the mentioned effects, we expect to consistently achieve an accuracy on the level of a few meters for the real-time navigation solution of commercial off-the-shelf single-frequency GNSS receivers in space.