Abstract
Abstract This study presents a highly reliable 3-phase 4-wire, three dual-buck full-bridge shunt active power filter (3 DB FB APF) for distribution system. The proposed topology uses three single phase dual buck full bridge inverter sharing the same dc-link capacitor with high utilization of dc-bus voltage. The dual buck inverter circuit composed of one power switch and one diode leg instead of two power switches conventional inverter leg effectually eliminate the undesirable “shoot-through” phenomenon occurs in conventional inverter circuit. The fuzzy and adaptive hysteresis current controller based id-iq control strategy has been adopted to generate optimized switching frequency. For validation, the proposed topology is implemented in the OPAL-RT LAB using OP5142-Spartan 3 FPGA. The dynamic performance of the proposed 3 DB FB APF is assessed for sinusoidal, unbalanced and non-sinusoidal voltage source condition with unbalanced non-linear load that is when both three-phase and single-phase loads are present in the system. Besides, the results with proportional-integral (PI) controller are compared with FLC in terms of harmonic compensation. Furthermore, a comparison has been made between split capacitor dual buck half bridge active power filter (2C DB HB APF) and proposed 3 DB FB APF based on switch power rating.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Emerging Electric Power Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
