Abstract
An innovative payload containing a sensitive mid-wave infrared camera was flown on an uncrewed aircraft system (UAS) to acquire thermal imagery along a reach of the Sacramento River, California, USA. The imagery was used as input for an ensemble particle image velocimetry (PIV) algorithm to produce near-continuous maps of surface flow velocity along a reach approximately 1 km in length. To assess the accuracy of PIV velocity estimates, in situ measurements of flow velocity were obtained with an acoustic Doppler current profiler (ADCP). ADCP measurements were collected along pre-planned cross-section lines within the area covered by the imagery. The PIV velocities showed good agreement with the depth-averaged velocity measured by the ADCP, with R2 values ranging from 0.59–0.97 across eight transects. Velocity maps derived from the thermal image sequences acquired on consecutive days during a period of steady flow were compared. These maps showed consistent spatial patterns of velocity vector magnitude and orientation, indicating that the technique is repeatable and robust. PIV of thermal imagery can yield velocity estimates in situations where natural water-surface textures or tracers are either insufficient or absent in visible imagery. Future work could be directed toward defining optimal environmental conditions, as well as limitations for mapping flow velocities based on thermal images acquired via UAS.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
