Quench detection and early warning based on thermoelastic strain rate for HTS tapes thermally triggered by heat spots

Abstract

The rapid detection and comprehensive monitoring of quench onset and evolution in high-temperature superconducting (HTS) materials remains immensely challenging because the normal zone propagation velocity in HTS materials is two or three orders of magnitude less than that in low-temperature superconductors. In this study, we experimentally and numerically explore quench events triggered by heat spots in yttrium barium copper oxide HTS tapes to characterize the quench onset and propagation. A multiplexed fiber Bragg grating sensor with multiple gratings was used to perform highly accurate strain measurements. Conventional voltage and temperature measurements were performed synchronously on the HTS tapes. A systematic comparison of these multifield signals during quench onset and development illustrated that the evolution of thermoelastic strain and strain-rate in HTS tapes captures the quench onset and propagation. A distinct feature was exhibited during the quenching of a pre-tensioned HTS tape: the thermoelastic strain initially relaxed but subsequently increased until the strain rate exhibited a significant slope change, which corresponded to the quench onset time. The thermoelastic strain in a nearly unconstrained HTS tape gradually increased until quenching occurred. A prominent characteristic for detecting quench onset in HTS materials have been revealed based on the change in the slope of the thermoelastic strain-rate or the second derivative of the strain remaining nearly constant. For a pre-tensioned HTS tape, the minimization of the thermoelastic strain or the strain-rate becoming zero may be a predictor that preceded the quench by ∼1–2 s, which can be, to a certain extent, regarded as an early warning. Another important and novel result was the experimental demonstration of global strain responses distant from the quench location in the pre-tensioned HTS tape, while the temperature and voltage detection are commonly localized methods. The mechanism behind these thermoelastic strain characteristics was further discussed and simulated from the induced Joule heating throughout the quench event. The measurements and numerical predictions suggested a new paradigm of quench detection based on the thermoelastic strain-rate in HTS materials.