Abstract

Recent studies have observed hysteresis loops in the macroscopic fundamental diagram (MFD). In particular, for the same network density, higher network flows occur during congestion onset than during congestion offset. To evaluate management strategies using the MFD, investigating the relationship between the size of these loops and network performance is needed. The existing literature has mainly discussed correlating loop width (difference in density) and height (capacity drop) with congestion heterogeneity, but has failed to prove a relationship between the capacity drop and traffic conditions. Moreover, quantification of the MFD loop in complex multimodal networks has not been investigated. The objective of this paper covers these aspects. We simulated the Sioux Falls network with different mode-share ratios (car and bus users) based on a multi-agent simulation, MATSim. We investigated the relationships between MFD loop size and congestion heterogeneity (standard deviation of density) and network performance (average passenger travel time), and found that both were directly correlated with loop width, while weakly correlated with loop height. Moreover, we divided the MFD loop into two parts according to congestion onset and offset periods and found that the heights of the two parts had opposite effects. Accordingly, we show why the relationship between capacity drop and congestion heterogeneity is not found in the literature. We also found that network performance inversely affected the height of part of the loop while the height of its other part increased with an increase in congestion heterogeneity. These results help to evaluate network performance in the presence of MFD hysteresis, leading to elaborated management decisions.

Highlights

  • Traffic congestion is a severe matter worldwide as it causes delays and air pollution

  • We investigated the relationships between macroscopic fundamental diagram (MFD) loop size and congestion heterogeneity and network performance, and found that both were directly correlated with loop width, while weakly correlated with loop height

  • MFDs that relate the average network density and flow have been used in the literature for network performance evaluation

Read more

Summary

Introduction

Traffic congestion is a severe matter worldwide as it causes delays and air pollution. Mazloumian et al [4] found similar MFD hysteresis loops in a simulation of an urban grid network They found, for different estimations of spatial distribution of congestion (represented by the standard deviation of the densities), that the MFD had different shapes. Quantifying MFD hysteresis loops and correlating them to different traffic characteristics may help in comparing the effects of different management strategies on network performance, leading to more appropriate management decisions. Saberi and Mahmassani [11], using loop detector data on freeways, found that the heterogeneous spatial distribution of network occupancy was independent of both the width of a hysteresis loop (difference in density) and its height (capacity drop); it was correlated with the area of the hysteresis loop.

Literature Review
Control Strategy Evaluation Based on MFDs
Hysteresis Phenomena
Characterization of MFD Hysteresis Loops
Simulation of a Multimodal Network
Characteristics of Multimodal Network and Mode-Choice Scenarios
Quantification of a MFD Loop
Relationship between Loop Metrics and Standard Deviation of Density
Part 1 loop
Relationship between Loop Metrics and Network Performance
Findings
Summary and Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call