Abstract
A magnetic linear actuator drop-on-demand printhead with interchangeable components is designed and fabricated. The manufacturing processes of all parts are carried out with simple techniques. A droplet generation relies on a linear motion from a piston inside a printhead chamber that causes a pressure wave to push an ink out from a nozzle-aperture. The motion is actuated by a voice coil liked actuator. The voltage applied across the actuator is significantly lower than the piezo actuator. The interchangeable components enable rapid configuration of a printhead to suit wide range of ink-materials. The prototype of our printhead was tested with inks prepared from glycerin-water solutions. The operability of the printhead was evaluated at actuated time ranging from 2 100 milliseconds. Our printhead was able to jet a single droplet of ink with viscosity up to 35 mPa.s. The drop size is comparable to other types of printheads.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.