Proposal and development of radial air‐gap coreless generator suitable for small wind turbine used in urban area

Abstract

AbstractIndependent distributed power generation using small wind turbines is becoming more widespread as wind power generation increases. Installation of small wind turbines in densely populated urban areas is not only useful from the viewpoint of extracting wind power sources in weak‐wind areas but also for making renewable energy easier to access when power supplies are closer to consumers. It is from this point of view that the authors proposed “urban wind power generation” using a collective system with a number of small vertical wind turbines, and have developed a suitable generator for low‐speed vertical wind turbines such as a Savonius windmill.Based on a standard coreless generator, the proposed generator is designed to make the direction of the magnetic flux radial in order to install the magnets and coils on the outer end of the generator. The change of magnet composition and flux direction maximizes the speed of the flux change and output voltage within a limited space. With the above configuration, the power of the proposed generator is independent of the diameter.In this report, the authors describe and evaluate the fundamental performance of a prototype of the proposed generator. Based on the experiments, a maximum output power of 283 W was obtained. The obtained starting torque is small enough to begin rotation under weak wind conditions of no more than 1 m/s. Therefore, it is clear that the proposed “radial” coreless generator is suitable for self‐starting and producing high power at low wind speed. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 167(1): 26– 34, 2009; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/eej.20695