Properties of wet-mixed fiber reinforced shotcrete and fiber reinforced concrete with similar composition

Abstract

Fiber reinforced shotcrete (FRS) is commonly used in slope protection, tunnel linings as well as structural repair and rehabilitation. For the design of shotcrete mixes, it is of interest to see if data on fiber reinforced concrete (FRC) can be employed as an initial guideline. In this study, various properties of FRS, including its compressive strength, flexural behavior, permeability and shrinkage behavior, are compared with FRC of similar composition. The results, based on five different mixes, indicate that the fabrication process (i.e., shotcreting vs. casting) can significantly affect compressive strength and permeability, but has relatively little effect on shrinkage behavior. The flexural strength of FRS is slightly higher than that for FRC in most cases, but the residual load carrying capacity in the postcracking regime can be significantly lower. Based on the differences in the properties of FRC and shotcrete, implications to material design are discussed.