Properties of the Silica Layer during the Formation of MCM-41 Studied by EPR of a Silica-Bound Spin Probe

Abstract

The properties of the silica layer during the formation of the mesoporous material MCM-41 were investigated by electron paramagnetic resonance (EPR) experiments carried out on a specifically designed, organo(trialkoxy)silane spin probe, SL1SiEt. Minute amounts of the spin probe were co-condensed with the silica source, tetraethyl orthosilicate (TEOS), in the synthesis of MCM-41 with cetyltrimethylammonium bromide (CTAB) under basic conditions. The mobility and location of the spin probe were followed in the CTAB micellar solution before the reaction, in the reaction mixture and in the final ordered material. It was found that the EPR spectra of hydrolyzed SL1SiEt throughout the room temperature part of the reaction are characteristic of a fast tumbling species, indicating that the silica is highly fluid prior to drying. After filtering, a slow motion type spectrum was observed, showing that the spin-label experiences considerable motional hindrance. The liquidlike behavior could be restored upon stirring the material in water. When the reaction is performed with a hydrothermal stage, the spectrum of SL1SiEt in the final product is the same as that of the room temperature synthesized material, but the addition of water did not restore the high mobility, due to a higher degree of silica cross-linking. The location of SL1SiEt throughout the formation process was obtained from electron spin-echo envelope modulation (ESEEM) measurements on MCM-41 prepared with CTAB deuterated either at the N-methyl or the alpha position and in a reaction carried out in D2O. Comparing the deuterium modulation depth, k(2H), induced by CTAB-alpha-d2, CTAB-d9, or D2O in CTAB micellar solutions of a number of reference spin probes with those of SL1SiEt revealed that the hydrolyzed SL1SiEt is located near the polar heads of the surfactant in the absence of base and TEOS. This supports the postulation of charge matching at the interface as a driving force for the formation of the mesostructure. Similar experiments carried out on reaction mixtures containing SL1SiEt showed a decrease of k(2H) from CTAB-alpha-d2 and CTAB-d9 compared to the micellar solution, exhibiting practically no time dependence. This indicates that the spin probe is pulled away from the micelle-water interface into the loosely linked, forming silica network. After drying, the modulation depth induced by CTAB-alpha-d2 and CTAB-d9 increases, showing that, once the water is removed, the silica walls contract around the micelles, pushing the silica-linked spin probe into the organic phase within the mesopores.