Abstract
Abstract In this work, manganese zinc ferrite components were manufactured by powder injection molding—PIM technology. A fine powder consisting of Mn 1− x Zn x Fe 2 O 4 with small addition of hematite α-Fe 2 O 3 as used in mass ferrite production was mixed with an organic binder (Solvent System) to form ferrite feedstock for powder injection molding—PIM technology. Excess of Fe 2 O 3 was present in the starting powder in order to suppress conversion of Fe 3+ to Fe 2+ ions which would lower the permeability. The ferrite feedstock was injected in a mold with a cavity shaped like a small cylinder with a hole on the main axis. Injection molded samples were then solvent and thermally debinded and sintered in different atmospheres: air, argon and nitrogen. The starting powder, injected green samples and sintered samples were characterized using X-ray diffractometry, scanning electron microscopy, thermogravimetry, differential thermal analysis as well as by magnetic measurements. Rietveld refinement of measured X-ray patterns was done to detect possible phase transformations of Fe 2 O 3 to other iron oxides through reduction by binder residues (carbon) at elevated temperatures during thermal debinding and sintering. Finally, the magnetic properties were measured by hysteresis graph and mutually compared for the injected samples that were sintered in air, argon and nitrogen. The obtained magnetic characteristics where found to be comparable with commercial samples prepared by traditional sintering technology.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call