Promoting bond durability by a novel fabricated bioactive dentin adhesive

Abstract

ObjectiveTo prepare a bioactive dentin adhesive and investigate its effect on promoting bonding durability of dentin. MethodsThe mineralization of the bioactive glass with high phosphorus (10.8 mol% P2O5–54.2 mol% SiO2–35 mol% CaO, named PSC) and its ability to induce type I collagen mineralization were observed by SEM and TEM. The Control-Bond and the bioactive dentin adhesive containing 20 wt% PSC particles (PSC-Bond) were prepared, and their degree of conversion (DC), microtensile bond strength (μTBS), film thickness and mineralization performance were evaluated. To evaluate the bonding durability, dentin bonding samples were prepared by Control-Bond and PSC-Bond, and mineralizated in simulated body fluid for 24 h, 3 months, and 6 months. Then, the long-term bond strength and microleakage at the adhesive interface of dentin bonding samples were evaluated by microtensile testing and semiquantitative ELIASA respectively. ResultsThe PSC showed superior mineralization at 24 h and induced type I collagen mineralization to some extent under weakly alkaline conditions. For PSC-Bond, DC was 62.65 ± 1.20%, μTBS was 39.25 ± 4.24 MPa and film thickness was 17.00 ± 2.61 μm. PSC-Bond also formed hydroxyapatite and maintained good mineralization at the bonding interface. At 24 h, no significant differences in μTBS and interface microleakage were observed between the Control-Bond and PSC-Bond groups. After 6 months of aging, the μTBS was significantly higher and the interface microleakage was significantly lower of PSC-Bond group than those of Control-Bond group. SignificancePSC-Bond maintained bond strength stability and reduced interface microleakage to some extent, possibly reducing the occurrence of secondary caries, while maintaining long-term effectiveness of adhesive restorations.